Fisher & Paykel AeroSmart DE27CW1 Installation Instructions And User Manual page 29

4-wire connections
Use approved 4-wire Power Supply Cord or a 4-wire Cable for Direct Wiring as described
on page 24.
Remove the terminal block cover plate.
1
Insert the power supply cable with a UL listed strain relief through the hole provided in the cabinet
2
near the terminal block. Do not tighten strain relief screw until wiring connections are complete.
Note: a strain relief must be used.
Remove center terminal block screw.
3
Remove appliance ground link by removing the ground connector screw (green screw).
4
Connect ground wire (green) of the power supply cord to the ground conductor green screw.
5
Tighten screw.
Connect the neutral wire (white) of the power supply cord to the center terminal screw of the
6
terminal block. Tighten screw.
Connect the red wire and black wire to the upper and lower terminal block screws marked with
7
the letter L. Tighten screws.
Refit terminal block cover by inserting the two tabs first on the rear panel of the dryer and
8
secure cover with securing screw.
Tighten Strain Relief screws.
9
2
Fig.30 Inserting the power cord
3
4
Note: If the appliance is moved back to a 3-wire
installation the ground link must be refitted.
Fig.31 Removing screws
Remove link
7
6
5
Fig.32 Connecting wiring
7
8
Fig.33 Refitting terminal block and screws
Installation instructions
strain relief
screws
strain relief
clamp sections
9
27