Designer Models - Fisher & Paykel DD24DCB7 User Manual

How to attend to a fault ‐ Designer models
36
If it's a 'U' code
U1: Turn on the water supply,
then press to resume the wash
program.
U4: Attend to the fault on
the other drawer. The drawer
displaying U4 is not faulty.
U6: Open the drawer and check the
spray arm.
Has the spray arm loosened or
come off its mounting?
YES
Refit the spray arm
following instructions
in section 'User
maintenance
instructions' , then close
the drawer and press
to resume the wash
program.
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
You have corrected the fault and can
continue to use your dishwasher as normal.
START HERE
Press to stop the beeping.
Try to open the drawer
(without using excessive force).
Can the drawer be opened?
YES
Check which program indicators
are lit on the wash program panel.
Look up what fault code the
indicators correspond to in the
table opposite.
Note down the code here:
NO
Water pressure
is too low. You
may need to have
a '4 litre' valve
installed on your
water supply.
YES
NO
If it's an 'E' code
Press . Wait a few
seconds, then press
again.
Is the light above the
button still red?
YES
Press . The Eco indicator and another set
of program indicators will briefly light up on
the wash program panel. Mark which ones
in the diagram below. This information will
help Fisher & Paykel identify the fault more
precisely. Which other indicators light up
when you press
Disconnect the dishwasher from the
power supply (unplug or switch off at
circuit breaker), turn off its water supply,
then contact Customer Care with the
NO
fault code information. See your 'Service
and warranty' booklet for contact details.
Press . Wait a few
seconds, then press
again.
Is the light above the
button still red?
NO,
IT'S
BLUE
The fault
has reset
and you
should
now be able
to open the
drawer.
You can
continue to
use it as
normal.
NO, IT'S
BLUE
?
YES