Classic Models - Fisher & Paykel DD24DCB7 User Manual

How to attend to a fault ‐ Classic models
34
If it's a 'U' code
U1: Turn on the water supply,
then press
program.
U4: Attend to the fault on
the other drawer. The drawer
displaying U4 is not faulty.
U6: Open the drawer and check the
spray arm.
Has the spray arm loosened or
come off its mounting?
YES
Refit the spray
arm following
instructions in section
'User maintenance
instructions' , then
close the drawer and
press to resume
the wash program.
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
YES
You have corrected the fault
and can continue to use your
dishwasher as normal.
START HERE
Press to stop the beeping.
Look up the fault code in the
table opposite and note it
down.
to resume the wash
NO
Water pressure
is too low. You
may need to have
a '4 litre' valve
installed on your
water supply.
NO
If it's an 'E' code
Press . Wait a few seconds, then
press again.
Has the fault code disappeared?
NO
Press . Another number will
briefly appear in the display. Note
this number down too. It will help
Fisher & Paykel Customer Care
identify the fault more precisely.
Disconnect the dishwasher from the
power supply (unplug or switch off at
circuit breaker), turn off its water supply,
then contact Customer Care with the
fault code information. See your 'Service
and warranty' booklet for contact details.
YES
The fault has
reset. You can
continue to use
your dishwasher.