Advertisement
FLEXTEC™ 500
INSTALLATION
ELECTRIC SHOCK CAN KILL.
ONLY QUALIFIED PERSONNEL SHOULD
PERFORM THIS INSTALLATION.
• TURN OFF INPUT POWER TO THE
POWER SOURCE AT THE DISCONNECT
SWITCH OR FUSE BOX BEFORE
WORKING ON THIS EQUIPMENT. TURN
OFF THE INPUT POWER TO ANY OTHER
EQUIPMENT CONNECTED TO THE
WELDING SYSTEM AT THE DISCONNECT
SWITCH OR FUSE BOX BEFORE
WORKING ON THE EQUIPMENT.
• DO NOT TOUCH ELECTRICALLY HOT PARTS.
• ALWAYS CONNECT THE FLEXTEC GROUNDING LUG
(LOCATED INSIDE THE RECONNECT INPUT ACCESS
DOOR) TO A PROPER SAFETY (EARTH) GROUND.
• ONLY A QUALIFIED ELECTRICIAN SHOULD
CONNECT THE INPUT LEADS TO THE FLEXTEC™
MACHINE. CONNECTIONS SHOULD BE MADE IN
ACCORDANCE WITH ALL LOCAL AND NATIONAL
ELECTRICAL CODES AND THE CONNECTION
DIAGRAM LOCATED UNDERNEATH THE CASE TOP
OF THE MACHINE. FAILURE TO DO SO MAY RESULT
IN BODILY INJURY OR DEATH.
INPUT AND GROUND CONNECTIONS
MACHINE GROUNDING
The frame of the welder must be grounded. A ground
terminal marked with the symbol shown is located
inside the reconnect/input connection area for this
purpose. See your local and national electrical codes for proper
grounding methods.
WARNING
B-1
INSTALLATION
Advertisement
