Pairing The Microphones - VocoPro TabletOke II Owner's Manual

Pairing the Microphones

If the Microphones experience signal loss or drop outs, the microphones should be re-synced to the receiver. In doing so,
the receiver will automatically change the operational frequency of each mic.
FOLLOW THE STEPS BELOW TO RE-SYNC THE MICROPHONES WITH A NEW FREQUENCY CHANNEL.
1 . Ensure the receiver and both microphones are powered off.
2 . Power receiver on - Press power button once (1x).
3 . Press and hold the Power/Pair ID button once more and hold until both Mic channel LEDs are flashing rapidly.
4 . When the Mic channel LEDs, Mic 1 & Mic 2, are flashing rapidly, turn on both handheld microphones one at a time
to assign the channels .
Note: The channel indicator lights on the receiver will then flash and the receiver will power off. This is normal.
5 . Power the receiver and both microphones back on and ensure that the Mic channel LEDs are solidly lit on the
receiver; this indicates the microphones were paired successfully.
Notes:
• The receiver WILL shut off when it pairs with a microphone, this is normal.
• The receiver will power off is the power button is continued to be pressed down once the flashing LED has selected mic.
1
2
3
4
12