Table of Contents
Advertisement
Network Stack Driver Support [Disabled]
[Disabled]
[Enabled]
Next Boot after AC Power Loss [Normal Boot]
[Normal Boot]
[Fast Boot]
DirectKey (DRCT) [Enabled]
[Disabled]
[Enabled]
Boot Logo Display [Auto]
[Auto]
[Full Screen]
[Disabled]
The following item appears only when you set the Boot Logo Display to [Auto] and [Full
Screen].
Post Delay Time [3 sec]
This item allows you to select a desired additional POST waiting time to easily enter
the BIOS Setup. You can only execute the POST delay time during normal boot. The
values range from 0 to 10 seconds.
This feature only works when set under normal boot.
The following items appear only when you set the Boot Logo Display to [Disabled].
Post Report [5 sec]
This item allows you to select a desired POST report waiting time.
Configuration options: [1 sec] - [10 sec] [Until Press ESC]
Bootup NumLock State [Enabled]
This item allows you to enable or disable power-on state of the NumLock.
Configuration options: [Disabled] [Enabled]
Wait For 'F1' If Error [Enabled]
This item allows your system to wait for the <F1> key to be pressed when error occurs.
Configuration options: [Disabled] [Enabled]
3-52
Select to skip the network stack driver from loading during POST.
Select to load the network stack driver during POST.
Returns to normal boot on the next boot after an AC power loss.
Accelerates the boot speed on the next boot after an AC power loss.
Disables the DirectKey button. The system will only power on or off when
you press the DirectKey button.
Allows the system to power on and go to the BIOS Setup directly when you
press the Reset button. Connect the 2-pin connector of the chassis reset
buton cable to the onboard DRCT header.
Sets the boot logo to display during POST.
Sets the boot logo display in full screen during POST.
Disables the boot logo display during POST.
Chapter 3: BIOS setup
Advertisement
Table of Contents
