Install Downdraft System - Jenn-Air W10253464B Installation Instructions Manual

Floor Mounting
A. #12 x 1⁵⁄₈" screws
B. Anti-tip bracket
Determine Equivalent Length of Vent System
This range is equipped with a dual range blower. It is shipped from
the factory for Low Range installations. If vent system equivalent
length exceeds 30 ft (9.1 m), the downdraft blower motor must be
converted to High Range for best performance. See "Calculating
Vent System Length."
To Convert:
Gently remove the spring loaded Restricter Ring from the blower
inlet by pressing one of the 3 springs.
A. Restricter ring
B. Spring
Determine which venting method to use: floor, rear wall, or left or
right side venting. Go to the section for your type of venting.
Rear Wall Venting
1. Mark the wall at the center of the cabinet opening.
12
A
B

Install Downdraft System

B
A
Wall Mounting
A
A. #12 x 1⁵⁄₈" screws
B. Anti-tip bracket
5. Using the Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1⁵⁄₈" screws provided.
2. Check for obstructions before marking the vent hole location.
Mark a horizontal line 8³⁄₁₆" (20.8 cm) from the floor. Mark a
vertical line up to a maximum of 2¼" (7.9 cm) from the right
side of the cabinet centerline.
A. Maximum 2¼" (7.9 cm) from
the right of center
B. 8³⁄₁₆" (20.8 cm) from floor
3. Draw and cut a 6¼" (15.8 cm) diameter hole.
A. 6¼" (15.8 cm)
B
A
B
A