Connecting To A Component-To-Vga Video Source - Epson H654A User Manual

Note: The projector converts the digital audio signal sent from your video source into a mono analog
signal for the internal speaker.
Parent topic:

Connecting to a Component-to-VGA Video Source

If your video source has component video ports, you can connect it to the projector using an optional
component-to-VGA video cable. Depending on your component ports, you may need to use an adapter
cable along with a component video cable.
1. Connect the component connectors to your video source's color-coded component video output
ports, usually labeled Y, Pb, Pr or Y, Cb, Cr. If you are using an adapter, connect these connectors
to your component video cable.
2. Connect the VGA connector to a Computer port on the projector.
3. Tighten the screws on the VGA connector.
If your image colors appear incorrect, you may need to change the Input Signal setting in the projector's
Signal menu.
Note: If you connected a game console, it may take a few seconds for your image to appear when you
switch to the game console's input source. To reduce the potential lag in response time to game
commands, set your game console's output format to a progressive signal of 480p, 720p, or higher. See
your game console documentation for instructions.
Parent topic:
Related references
Optional Equipment and Replacement Parts
Connecting to Video Sources
Connecting to Video Sources
31