Battery Care - Fluke Ti90 User Manual

Battery Care

To prevent personal injury and for safe operation of the Product:
•
Do not put battery cells and battery packs near heat or fire.
Do not put in sunlight.
•
Do not disassemble or crush battery cells and battery packs.
•
Remove batteries to prevent battery leakage and damage to
the Product if it is not used for an extended period.
•
Connect the battery charger to the mains power outlet before
the charger.
•
Use only Fluke approved power adapters to charge the
battery.
•
Keep cells and battery packs clean and dry. Clean dirty
connectors with a dry, clean cloth.
To prevent damage:
•
Do not expose Product to heat sources or high-temperature
environments such as an unattended vehicle in the sun.
•
Do not store the Imager on the charger for more than 24
hours as reduced battery life may result.
•
Charge the Imager for a two-hour minimum at six-month
intervals for maximum battery life. Without use, the battery
will self-discharge in approximately six months. Batteries
stored for long periods will need two to ten charging cycles
for full capacity.
•
Always operate in the specified temperature range.
Do not incinerate the Product and/or battery. Go to Fluke's
website for recycling information.
Shop for Fluke products online at:
Performance Series Thermal Imagers
 Warning
 Caution
  Caution
MyFlukeStore
www.
Maintenance
1.877.766.5412
.com
57