How To Charge The Battery; Two-Bay Battery Charger Base; On-Imager Ac Power Socket - Fluke Ti90 User Manual

How to Charge the Battery

Before you use the Imager for the first time, charge the battery for a minimum
of two and one-half hours. The battery status shows on the five-segment
charge indicator.
New batteries are not fully charged. Two to ten charge/discharge
cycles are necessary before the battery charges to its maximum
capacity.
To charge the battery, use one of the options that follow:

Two-Bay Battery Charger Base

1. Connect the ac power supply to the ac wall outlet and connect the dc
output to the charger base.
2. Put one or two smart batteries into bays of charger base.
3. Charge batteries until charge indicators show "full."
4. Remove smart batteries and disconnect the power supply when batteries
are fully charged.

On-Imager AC Power Socket

1. Connect the ac power adapter into an ac wall outlet and connect the dc
output to the Imager's ac power socket.  flashes in the upper left-hand
corner of the display while the battery charges with the ac power adapter.
2. Charge until the charge indicator on the display does not flash.
3. Disconnect ac power adapter when the smart battery is fully charged.
Make sure that the Imager is near room temperature before you
connect it to the charger. See the charging temperature specification.
Do not charge in hot or cold areas. When you charge in extreme
temperatures, battery capacity may be decreased.
 shows in the upper left-hand corner of the display when the Imager is
connected to ac power and the battery is removed. When the Imager's power is
off and the ac power adapter is connected,  flashes in the center of the
display to show that the battery charge is in process.
Shop for Fluke products online at:
Performance Series Thermal Imagers
Note
Note
MyFlukeStore
www.
Before You Start
1.877.766.5412
.com
9