Preamble/Postamble Configuration - Wasp WCS 3900 Programming Manual

The 'Preamble/Postamble' configuration is used to add a prefix or suffix set of
characters to the bar code value. Up to 8 characters may be added for each
option separately. Preamble and postamble characters can function
concurrently, but need to be configured separately.
To add preamble or postamble characters, follow the steps below:
1) Scan the 'Clear Pre/Postamble' bar code on this page.
2) Scan the 'Preamble' or 'Postamble' bar code.
3) Use Appendix B on pages 31-34 to locate the characters you want to
add as preamble or postamble characters. Make sure that you scan the
bar code associated with each letter before preceding to the next
character. For example, to add the letter "A," scan the bar code
corresponding to the letter "A" on page 33. The letter "A" will always
appear in your data as prefix or suffix to the bar code value.
4) Scan the corresponding 'Pre/Postamble' bar code on this page to exit
this setting.

Preamble/Postamble Configuration

Clear Pre/Postamble
Preamble
Postamble
11
Chapter 5