Kenwood KDC-U5049DAB Instruction Manual page 37

Determining the antenna installation location
When installing the antenna on the left side
Front pillar
Earth sheet
Amplifier G
Where the earth sheet of Amplifier G can be pasted on the metal part of the front pillar.
1
• *
Antenna Installation
1 Check the installation location.
Wipe the area where antenna film F,
2
amplifier unit G, and earth sheet are
pasted with the included cleaner I.
The coating on the metal surface need not
be removed.
Wait until the glass surface is completely
■
dry before pasting.
If the glass surface is cold, such as during
■
winter, warm it with defroster or dryer.
Remove the separator (tag I) of antenna
3
film F horizontally and paste the
antenna on the front glass.
Remove the separator gently.
■
Do not touch the pasting surface
■
(adhesive side) of the antenna film F.
Remove the separator (tag II) of antenna
4
film F vertically and paste the antenna
gently while applying pressure.
150 mm
70 mm *
1
Antenna film F
When installing the antenna on the right
side
Amplifier G
150 mm
Antenna film F
5 After pasting, rub the element in the
glass surface in the direction of the arrow
shown in the figure to bond it.
Remove the application film (tag III).
6
Do not touch the feeder terminal of the
■
element. Also, do not apply any glass
cleaner.
Earth sheet
70 mm *
1
Feeder terminal
Continued to next page
English
37