Bluetooth Setup - Kenwood KDC-U5049DAB Instruction Manual

"ENTER 2" is displayed. When a beep is
8
heard, say the same voice tag as that you
said in step 7 within 2 seconds.
"COMPLETE" is displayed.
Press the volume knob to return to step
9
5.
■
Set the voice tag for all the 5 categories. If
the voice tag is not registered for all the
categories, the Phone book may not be
recalled by voice command.
Item
PAIRING
DEVICE SEARCH Registers a Bluetooth device (pairing).
(For details, see page 24.)
PHONE SELECT Selects a cell-phone connection.
(For details, see page 25.)
AUDIO SELECT Selects a Bluetooth audio player connection. (For details, see page 25.)
S-DVC SELECT (For details, see page 24.)
DEVICE DELETE Cancel registration of the Bluetooth device.
1. Turn the volume knob to select the Bluetooth device, then press to confirm.
2. Turn the volume knob to select "YES", then press to confirm.
SMS DOWNLOAD Download a short message. (For details, see page 28.)
VOICE TAG
PB NAME EDIT Registers voice for voice recognition and voice to select the Phone number category in Phone book.
(For details, see page 25.)
PN TYPE EDIT
DETAILED SET
PIN CODE EDIT Specify the PIN code required when registering this unit using the Bluetooth device. By default, "0000" is
specified.
1. Turn the volume knob to select the number.
■
■
2. Press the volume knob to register a PIN code
AUTO ANSWER OFF: Does not answer the phone call automatically. ; 0: Automatically answers the phone call at once. ;
1 – 8 * –99: Automatically answers the phone call after lapse of 1 – 99 seconds.
BT HF/AUDIO FRONT *: Outputs audio from the front-left and front-right speakers. ; ALL: Outputs audio from the all
speakers.
CALL BEEP ON *: Outputs a beep from the speaker upon reception of an incoming call. ; OFF: Cancels.
BT F/W UPDATE Display the firmware version and update the firmware.
26
English
To move to the next digit, press ¢.
To delete the last digit, press 4.

Bluetooth Setup

1 Press and hold the volume knob to enter
Bluetooth mode.
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to make a
3
selection, then press to confirm.
■
See table below for selection.
■
Repeat step 3 until the desired item is
selected/activated.
■
Press
Hold
4
■
To exit Bluetooth mode, press
Selectable setting (Preset: *)
to return to the previous item.
to finish the procedure.
SRC.