Setting The Clock - Sharp MD-M1 Operation Manual

SETTING THE CLOCK

In this example, the clock is set for the
24-hour (0:00) system.
2
4,6,8
1
1
Press the POWER button to turn the power on.
2
Press the CLOCK button.
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
3
Within 5 seconds, press the ENTER button.
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
4
Press the or button to select the time
display mode.
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
→The 24-hour display will appear.
"0:00"
→(0:00 - 23:59)
"12:00 AM" →The 12-hour display will appear.
→(AM or PM 12:00 - 11:59)
"0:00 AM" →The 12-hour display will appear.
→(AM or PM 0:00 - 11:59)
Note that this can only be set when the unit is
first installed or it has been reset (see page 40).
5
Press the ENTER button.
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
6
Adjust the hour by pressing the
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
When the button is pressed once, the time will
increase by 1 hour. When the
once, the time will decrease by 1 hour.
When the 12-hour display selected, "
change to " " automatically.
PM
7
Press the ENTER button.
8
Adjust the minutes by pressing the
button.
3,5,7,9
When the
will increase by 1 minute. When the
pressed once, the time will decrease by 1 minute.
The hour setting will not advance even if min-
utes advance from "59" to "00".
9
Press the ENTER button.
The clock starts operating from "0" seconds.
kHz REC
MHz SLEEP
(Seconds are not displayed.)
To see the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds
kHz REC
MHz SLEEP
even if stand-by mode.
Note:
The clock display will flash on and off at the push
of the CLOCK button when the AC power supply
is restored after a power failure occurs or after
the AC power cord is disconnected.
If this happens, follow the procedure below to
change the clock time.
1
To change the clock time:
2
Press the CLOCK button.
3
Within 5 seconds, press the ENTER button.
Perform steps 6 - 9 above.
1
To change the time display mode:
2
Reset the microcomputer (see page 40).
kHz REC
MHz SLEEP
Perform steps 1 - 9 above.
or button.
kHz REC
MHz SLEEP
button is pressed
" will
AM
11
DISC TOC
TRACK
MEMORY
RANDOM
kHz REC
TOTAL
MHz SLEEP
REMAIN
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL kHz REC
REMAIN MHz SLEEP
button is pressed once , the time
DISC TOC
TRACK
MEMORY
RANDOM
kHz REC
TOTAL
MHz SLEEP
REMAIN
or
button is