Minidisc Operation - Sharp MD-M1 Operation Manual

MINIDISC OPERATION

MD playback
1
H
2
2
1
DISC
MEMORY
RANDOM
TOTAL
REMAIN
Disc name
(Displayed only when a disc name has
been programmed)
DISC TOC
TRACK
MEMORY
RANDOM
TOTAL
REMAIN
Total number of tracks
3
7
4
H
4
Flash
kHz REC
MHz SLEEP
kHz REC
MHz SLEEP
Total playing time
14
1
Press the POWER button to turn the power on.
2
Press the MD button.
3
Load a MiniDisc in the direction indicated by the
arrow on the MiniDisc, with the labeled side fac-
ing up.
The total number of tracks and the total playing
time on the MiniDisc will be displayed.
4
Press the 0 6 button.
If the MD has a track name, the name will ap-
pear and scroll across the display. Then, the
elapsed playing time will appear.
If the MD has no track names, the elapsed play-
ing time will appear.
When the last track has been played back, the
unit will stop automatically.
To interrupt playback:
Press the 0 6 button.
" 6 " will appear.
Press the 0 6 button again to resume playback
from the same point.
To stop playback:
Press the button.
To remove a MiniDisc:
Press the 7 MD EJECT button.
Notes:
If TV or radio interference occurs when using the
MD, move the unit away from the TV or radio.
Although MiniDiscs will not normally skip due to
vibration, you may hear a skip in the sound if
there is continuous vibration.
If the volume is turned up too high, a skip may
occur depending on the contents of the MD.
If this happens, turn the volume down and the
skipping should stop.
If an error message is displayed during MD
operation, see "ERROR MESSAGES" on
page 39.