Assembly - NordicTrack A.C.T. NTCW90907.1 User Manual

ASSEMBLY

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver
wrench , and a rubber mallet
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
M8 Nylon
Locknut (63)–4
M4 x 16mm M4 x 16mm
Round Head Screw (67)–9
Screw (95)–4
M8 x 13mm M8 x 25mm Flat
Patch Screw
(62)–8
M8 Split
Washer (80)–8 Washer (79)–10
M4 x 30mm
Screw (74)–4
Patch Screw
(68)–6
.
M10 Split M10 Washer
(64)–4
M6 x 13mm
Patch Screw
(78)–8
M8 x 45mm Button
Bolt (70)–4
5
, an adjustable
23mm x 19mm
Wave Washer
(76)–4
M6 x 32mm Patch
Screw (96)–4
M10 x 19mm Patch
Screw (61)–14