Table of Contents
Advertisement
WARNING: IMPORTANT!
BEFORE LIGHTING...
Inspect the gas supply hose prior to turning the gas
"ON". If there is evidence of cuts, wear, or abrasion,
it must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure
regulator and hose assembly supplied with the unit
should be used. Never substitute regulators for those
supplied with the grill. If a replacement is necessary,
contact the factory for proper replacement.
Hand tighten the regulator (type QCC1) onto the
tank. Leak check the hose and regulator connections
with a soap and water solution before operating the
grill (see assembly instruction page17).
TO LIGHT THE GRILL BURNER:
Make sure all knobs are "OFF" then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your grill has an exclusive patented built-in ignition.
The igniter is built in to the valve. To ignite each
burner simply push and turn the control knobs to the
HI setting, you will hear the valve click as it sends a
spark to the pilot flame. If the burner does not light,
wait 5 minutes for any excess gas to dissipate and
then retry.
Flame Characteristics
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however,
WARNING: IMPORTANT!
USING THE SIDE BURNER:
Inspect the gas supply hose prior to turning the gas "ON". If there is evidence of cuts, wear or abrasion, it must
be replaced prior to use. Do not use the side burner if the odor of gas is present.
WARNING: Always keep your face and body as far away from the burner as possible when lighting.
LIGHTING INSTRUCTIONS
To light the side burner, remove any cooking utensils from the burner grate. Push and turn the control knob
counterclockwise to the "HI" position. If the burner does not light, turn the control knob to "OFF". If the smell of
gas is detected and the igniter is not functioning, immediately turn the control knob "OFF". Allow 5 minutes for
any accumulated gas to dissipate. If the side burner igniter is not functioning, see the following section for match
lighting.
MATCH LIGHTING
Hold a lit extended match or lighter near the side burner ports, turn the control knob counterclockwise to "HI".
Move your hand immediately once the burner is lit. Rotate the control knob to the desired setting.
LIGHTING INSTRUCTIONS
USING THE SIDE BURNER
variations in the local gas supply may take minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of these
conditions exist call our customer service line. If the
flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the burner,
it indicates too much air.
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts then
the burner can be match lit.
If you've just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away
from the grill as possible. Insert a lit extended match
or lighter through the cooking grids to the burner.
Press the control knob and rotate left to the HI
setting, continue to press the knob until the burner
ignites. Burner should light immediately. If the burner
does not light in 4 seconds turn the knob off, wait 5
minutes and try again.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before each
use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1-800-913-8999.
20
Advertisement
Table of Contents
