Table of Contents
Advertisement
Side burner valve assembly:
Step 1: Insert valve assembly through side
panel
Step 3: Insert valve stem assembly into burner
venturi
Valve stem
Valve
Step 5: Replace "U" brackets with 4(four)
Screws ( DO NOT TIGHTEN)
Step 7: Tight all 4(four) screws on the "U"
brackets on the burner, then connect
the ignition wire on to valve.
Ignition wire
Valve
(Side panel, right #29)
#22
Step 2: Remove 4(four) screws & washers
from the "U" brackets on the side
burner
Step 4: Insert valve stem assembly through knob
hole to the control panel
Step 6: Align & tighten knob bezel & valve
stem with 2(two) screws & washers
as shown below.
Step 8: Place knob on valve stem, then screw
the knob by using the wrench tool.
11
(#22)
(Control panel #22)
(Knob bezel in bag)
(Wrench tool enclosed in bag)
Advertisement
Table of Contents
