Table of Contents
Advertisement
Command
%P=
%P?
%P=D
%P=(blank)
The %P=D command disables remote configuration. To enable remote
configuration, insert another security code.
IMPORTANT: Do not forget your remote security code. Keep your
code in a safe place. If you do forget your code, contact Technical
Support. Refer to the "Calling Technical Support" section on page 12-2.
Entering Remote Configuration — %T=, &T
This mode of operation allows you to view or modify the option set of a
compatible remote modem. Enter the %T= (security code of
remote) command to initiate remote configuration.
The modem is shipped from the factory with security code (blank).
This allows remote configuration by using (blank) as the security
code.
Command
%T=
&T
Remote Configuration can also be specified by the dial command by
placing %T (password) after the dial digits (the equal sign is left
off). For example,
ATD 555-1212%T01234
Enabling/Disabling Remote Configuration — *RA
The *RA commands enable and disable remote configuration.
Command
*RA
*RA1
Operation
Sets security code to a value 0 to 99999999
entered after the equal sign
Requests local security code to be displayed
Access for remote configuration is not possible
when security code is disabled
Clears security code
Operation
This command followed by the correct security
code establishes remote configuration
Exits remote configuration
Operation
Disable remote configuration
Enable remote configuration
V.3600
AT Commands
5-43
Advertisement
Table of Contents
