Weider XRS 20 User Manual page 15

USING THE LEG LEVER
5
To use the Leg Lever (5), slide a weight plate (C)
(not included) onto the Olympic Adapter (8) and
secure it with a Weight Clip (41). Note: When using
the Leg Lever, remove the Curl Bar (17) (see
REMOVING THE CURL BAR below).
8
C
41
REMOVING THE CURL BAR
When performing exercises that do not require the
5
Curl Bar (17), pull the Curl Bar Pin (33) out of the
Leg Lever (5) and remove the Curl Bar.
17
When attaching the Curl Bar (17), insert the Curl Bar
Pin (33) completely through the Leg Lever (5).
33
ADJUSTING THE WEIGHT RESTS AND THE
SAFETY SPOTTERS
To adjust the height of the Weight Rests (12), raise
35
the Weight Rests to the desired height and tighten
12
an Adjustment Knob (35) into each Upright (11).
Make sure that the Weight Rests are at the same
D
11
height and that the Adjustment Knobs are fully
tightened into the Uprights. 13
35
To adjust the position of the Safety Spotters (13),
12
move the Safety Spotters to a different set of pegs
(D) on the Uprights (11). Make sure that the Safety
D
Spotters are at the same height.
11
13
15