How To Use - Panasonic MJ-H100 Operating Instructions Manual

HOW TO USE

Wash all detachable parts and dry well before using the appliance for the first time (refer to page 8).
Unplug when assembling the unit. Before plugging in, ensure Switch is switched OFF.
1 Place the Container Unit onto the Motor
Housing.
 Make sure the Spout and the Clamp (both
sides) are positioned at the same direction
as illustrated.
 Make sure the Container Unit sits properly
on the Motor Housing.
|
O
5 Place the Juicer as shown.
 Make sure the Spout is in the downward
position when juicing.
 It is recommended to use a similar mug as
shown to promote ease of use.
6 Plug in and switch ON.
7 Insert the ingredients one by
one and push them slowly
into the Feeding Tube using
the Food Pusher.
6
Note:
• Ingredients that are not recommended:
Soft fruits that produce puree and can clog the Spinner – e.g. bananas, peaches, apricots etc.
Low juice ingredients which can block the product – e.g. fresh basil leaf etc.
Hard ingredients which can cause product malfunction - e.g. sugarcane, coconut etc.
• Please remove hard seeds and stones from fruit before juicing such as guava etc. Hard seeds that are
difficult to be removed such as pomegranate is prohibited for juicing.
• During initial usage, the appliances might have some unpleasant smell (slight burn smell) but this
condition is normal.
• Some ingredients may produce a lot of pulps that will accumulate at the Container Cover which will
cause operation to stop. (CIRCUIT BREAKER PROTECTION: refer to page 6)
• Make sure all parts are correctly mounted before you switch ON the appliance.
• Some ingredients may accumulate at the Container Cover and Spinner. If so, please switch OFF the
Juicer and clear the accumulated ingredient before continuing to juice to prevent leakage.
2 Place the Spinner in the
Container Unit and fix it
into position.
3 Place the Container Cover
onto the Container Unit.
4 Rotate the Clamp (both sides) as
shown while pushing the Container
Cover until a locking sound is heard.
 It is normal for the Container
 Make sure hand or fingers are
8 After use, switch OFF and unplug.
 Ensure the Spinner is fully stopped before
 Ensure the Spinner is fully stopped before
 Some pulp might resides on the Container
7
|
O
Cover to float a little causing
a small gap between Container
Cover and Container.
not in the way during the
clamping process to avoid
injury.
pushing the Spout up to prevent juice from
dripping when removing the cup from the
Juicer.
releasing the Clamp (both sides).
Cover depending on the ingredients and
amount.
|
O
3
2
|
O
|
O
Gap
|
O
7