Advertisement
Contents
Connections
Procedure for speaker settings (Auto
Setup)
Preparation
Measurement
Front panel
Display
Playback
Finish
Rear panel
Settings
1
Mount the Sound calibration microphone on a tripod
and place it in the main listening position.
When installing the Sound calibration microphone, point the tip of
the microphone toward the ceiling and adjust the height to match the
height of the ears of a listener in a seated position.
2
If using a subwoofer capable of the following
adjustments, set up the subwoofer as shown below.
n When using a subwoofer with a direct mode
Set the direct mode to "On" and disable the volume adjustment
and crossover frequency setting.
n When using a subwoofer without a direct mode
Make the following settings:
Volume : 12 o'clock position
0
Crossover frequency : Maximum/Highest Frequency
0
Low pass filter : Off
0
Standby mode : Off
0
88
Remote
Tips
Appendix
Index
Advertisement
