Table of Contents
Advertisement
CONNECTION/INSTALLATION
❏ Supplied accessories for installation
1 Wiring harness × 1
2 Flat head screws (M5 × 7 mm) × 6
3 Round head screws (M5 × 6 mm) × 6
4 USB extension cable (1.0 m) × 1
5 GPS antenna (3.5 m) × 1
6 Metal plate × 1
7 Steering Remote cable × 1
8 Microphone (3 m) × 1
9 Trim plate × 1
60
❏ Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wiring harness wires in the
following order: ground, battery, ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
• Make sure that the unit is installed securely
in place. If the unit is unstable, it may
malfunction (e.g., the sound may skip).
7
Reconnect the
"
battery.
8
Configure <Initial SETUP>. (Page 4)
Installing the unit
❏ Installing the unit using the mounting
"
bracket removed from the car
2 or 3
• Select the appropriate type of screw for the
mounting bracket: flat head (2) or round head
(3).
❏ Installing the trim plate
Attach the trim plate (9).
Car Bracket
2 or 3
9
Advertisement
Table of Contents
