Advertisement
6
Installing the Recycler
Blades
Parts needed for this procedure:
2
Recycler blades (sold separately)
Procedure
WARNING
A blade is sharp. Contact with a sharp blade
can cause serious personal injury.
Wear gloves or wrap sharp edges of the blade
with a rag.
Install the recycler blades onto the mower; refer to
the Parts Catalog for your machine for the blade part
number and the Operator's Manual for your machine
for installation instructions.
7
Converting the Mower
Deck for Rear-Discharge
Operation
Parts needed for this procedure:
6
Flange-head capscrews
Preparing to Remove the Mulching
Kit
1.
Prepare the mower; refer to
Mower (page
2).
2.
Remove the recycling blades; refer to the
Operator's Manual for your machine.
Removing the Kicker Fittings
Note:
Determine the left and right sides of the
machine from the normal operating position.
1.
At the bottom, left side of the mower deck,
remove the 2 carriage bolts (3/8 x 1 inch) and 2
flange locknuts (3/8 inch) that secure the kicker
1 Preparing the
6
fitting to the deck, and remove the kicker fitting
(Figure
7).
Note:
Retain the carriage bolts and kicker fitting
for installing the mulching kit.
Figure 7
1. Flange locknut (3/8 inch)
2. 10 mm (3/8 inch) hole
(mower deck)
3. Kicker fitting
2.
Install 2 flange-head capscrews (3/8 x 1 inch)
into the 10 mm (3/8 inch) holes in the mower
deck
(Figure
8) and secure the capscrews with
2 flange locknuts (3/8 inch) that you removed
in step 1.
Figure 8
1. Flange locknut (3/8 inch)
2. 10 mm (3/8 inch) hole
(mower deck)
3.
At the bottom, right side of the mower deck,
remove the 2 carriage bolts (3/8 x 1 inch) and 2
g283727
4. Carriage bolt (3/8 inch)
5. Front of the machine
g284329
3. Flange-head capscrew
(3/8 x 1 inch)
Advertisement
