Engine Components - MULTIQUIP MAYCO LS300G Operation Manual

8
7
6
Figure 8. Zenith Power Products ZPP 428 Engine Components
The engine (Figure 8) must be checked for proper
lubrication and filled with fuel prior to operation. Refer to the
manufacturer's engine manual for instructions and details
on operation and servicing.
1. Oil Dipstick — Remove the dipstick to determine if
the engine oil level is low. If low, add oil as specified
in Table 4.
2. Fan Blades — To provide adequate cooling, ALWAYS
remove dirt and debris from the fan blades.
3. V-Belt — Driven by the engine crankshaft during
operation, drives the water pump/fan as well as the
alternator.
4. Alternator — Provides power to the electrical system.
Replace with only manufacturer's recommended
replacement parts.
5. Oil Pan — Holds a maximum of 4 quarts (3.8 liters)
of engine oil.
PAGE 28 — MAYCO LS300G CONCRETE PUMP • OPERATION MANUAL — REV. #2 (09/09/19)
1
4
3
5

ENGINE COMPONENTS

2
6. Starter/Solenoid — This engine uses a 12VDC,
2.7 kW (3.7 HP) starter motor with solenoid.
7. Oil Filter — Prevents dirt and other debris from entering
the engine. Service the oil filter as recommended in the
Maintenance section of this manual.
8. Spark Plug — Provides spark to the ignition system.
Set the spark plug gap according to the engine
manufacturer's instructions, and clean the spark plug
once a week.
9. Oil Filler Port/Cap — Remove this cap to add engine
oil to the crankcase.
10. Oil Drain Bolt — Remove to drain oil from the
engine crankcase.
9
10