EverFocus EDR410H Instruction Manual page 34

N.O. Trans.: When th
no matter how long the
N.O.
N.C. Trans.: When the alarm is triggered, buzzer starts to function
no matter how long the alarm duration is set until you set it back to
N.C.
ACTIVE CAMERA: This field is to activate camera you want to have
the alarm enabled too. For example if you had an
detector on camera one you would set this option to camera one. The
Default from the factory is set to on. To change this, simply use t
Dial on the DVR. Press the Enter key to make your selection.
Active camera setting, from camera 01~08. You can set the cam
which corresponds to the place where the alarm is located.
Note: The recording camera number in an event depends on the
alarm number, and the active camera imag
recorded. Example: You assign camera 3 as the active camera to
alarm 1. When the alarm 1 is triggered, camera 3 will be
displayed and came
DURATION: The amount of time an alarm event will record - from 1
sec to 99 seconds. The default value is 5 seconds.
ALARM OUTPUT: This will transmit a signal to another device. The
setting of alarms are NONE = not activated and 1 = one output
signal transmitted.
ALARM EMAIL: Select "YES" for sending an email when alarm
occurs. The email address can be set in the NETWORK SETUP
MENU.
BUZZER: Audible alarm buzzer.
ENABLE: To enable an alarm buzzer.
DISABLE: To disable an alarm buzzer.
ALARM NETWORK:
Y ES: Enable alarm network.
N O: Disable alarm network.
e alarm is triggered, buzzer starts to function
alarm duration is set until you set it back to
ra 1 will be recorded.
26
external motion
he Jog
era
es will not be