Central Pneumatic 94605 Assembly And Operation Instructions Manual page 5

3. Move the Paint Shaker aside, and drill holes using a drill matching the
size of the Base (1) mounting holes.
4. Mount Paint Shaker to the workbench using supplied nuts and bolts
hardware. If the supplied hardware will not accommodate the workbench,
other hardware will need to be purchased.
Air Connection
Wrap a small amount of Teflon ® joint tape (not supplied) around the
1.
treads of the Control Valve (6), then screw it into
the Inlet Fitting (7) until secure. Do not over-
tighten. Thread on the Oiler (52) to the Control
Valve (6). fill the Oiler with oil. See page 6.
2. Attach the compressor air hose (not supplied)
to the Control Valve (6). Securely tighten.
3. optional: Attach an air quick-coupler (not sup-
plied) between the air hose and Oiler (52) for fast disconnects.
4. Tighten all couplings and fittings.
Dirt, water, and the lack of pneumatic tool oil are major causes for tool wear.
Install an optional air filter (not supplied), as illustrated below for better perfor-
mance.
Connect the Pneumatic Paint Shaker, air hose, filter, to the Compressor Air
Outlet as illustrated below.
The air filter (not supplied) is recommended but not mandatory for operation.
If the filter is not used, connect the air supply hose directly to the compressor
air inlet fitting. Use pipe thread seal or Teflon tape on all threaded connec-
tions.
Paint
Shaker
SKU 94605 For technical questions, please call 1-800-444-3353.
AIR FIlTER CoNNECTIoN
Page 5