Table of Contents
Advertisement
2.3 - ICM packaging
Packaged on wooden pallets of 10 ICM units and protected by
heat-shrunk or stretchable plastic film.
NOTE:
If "Export" packaging is needed, please contact your local
Carrier representative.
Palletized
Units per
Length
pallet
(mm)
Size 1.3 10
1600
Size 2.3 10
1700
6
1 800
Size 4.4
NOTE:
When receiving a shipment of units, check at once that none
of the packages has been damaged. To maintain the
protection of the packaging as long as possible, do not open
any package until just before a unit is to be installed.
2.4 - Receiving a shipment - installation methods
When receiving a shipment, check the condition of the goods
and report any damage in transit to the shipping company. Do
not unpack the units until just before they are due to be
installed, and make sure they are as close as possible to the
installation site when unpacking them. Do not stack the units
and do not place heavy articles of any sort on them.
LATERAL FILTER ACCESS OPTION
FRESH AIR CONTROLLER
10
Width
Height
(mm)
(mm)
1100
1500
1350
1500
1 350
1 200
FILTER ACCESS OPTION FROM BELOW
WARNING:
When moving the units do not use water pipe connections or
condensate drain stubs, valves or flexible pipes as handles.
The presence of electrical components creates hazards to those
installing and servicing these units. Only properly qualified
electricians may be authorized to instal, service and repair
these units. Some routine maintenance such as cleaning of the
coils and filter replacement may be entrusted to non-skilled
personnel. Before carrying out any work, qualified technicians
must familiarize themselves with the contents of this manual
Weight
(kg)
and all informative tags and labels attached to the units. It is
320
essential to adhere to all applicable safety regulations. Wear
450
eye protectors, work gloves and non-flammable clothing when
410
soldering or brazing. Always have a fire extinguisher of the
appropriate type close at hand.
WARNING:
Disconnect the power supply to the unit and to any
accessories before carrying out any work on a unit.
Do not instal a unit where flammable gases or products of an
acidic or alkaline character may be present. The
copper/aluminium coil or plastic components inside the unit
could suffer irreparable corrosion damage in their presence.
WARNING:
Failure to take proper account of the above advice and
unauthorised modification of the electrical connections will
render the warranty on the product null and void.
FILTER TOP ACCESS
OPTION
FAN MOTOR ASSEMBLY
DRAIN PAN AND
COIL ASSEMBLY
FAN ACCESS
PANELS
Advertisement
Table of Contents
