Operating Instructions - CrimeStopper SP-101 Installation & Operating Instructions Manual

OPERATING INSTRUCTIONS

4 BUTTON REMOTE TRANSMITTER
ACTIVE ARMING
To arm the alarm and lock the doors, press the #1 Button (Lock
Symbol) on the transmitter. You will hear a single siren chirp and the
lights will flash once. The system will arm, the doors will lock and the
starter will be disabled if these optional features are installed. After a
short 5 second delay to allow vehicle and electronics to settle, the
system will be completely armed. The alarm status LED in the vehicle
will begin flashing.
SILENT ARMING
To silently arm the alarm and lock the doors, press the #3 Button
(X Symbol) on the transmitter. Only the lights will flash once.
PASSIVE ARMING
If programmed, Passive (Automatic) Arming will occur 40 Seconds after
the Ignition is Turned Off and the last door has been closed. The LED
will begin flashing rapidly while counting down. If a door is reopened,
the system will wait for the door or zone to close before arming. The
unit will flash the lights once. Doors will lock if the "Passive Locking"
feature is ON. Passive Arm/Lock may qualify for insurance discounts,
check with your agent or proprietor
DISARMING
To Disarm the Alarm and Unlock the doors, press the #2 Button (Unlock Symbol) on the transmitter. You will
hear 2 siren chirps and the lights will flash twice. LED stops flashing. Doors will unlock and dome light will turn
on if these optional features are installed.
SILENT DISARMING
To silently disarm the alarm and unlock the doors, press the #3 Button (X Symbol), then press the #2 (Unlock
Symbol) on the transmitter. Only the lights will flash twice.
TRANSMITTER BATTERY REPLACEMMITTER = GP27A (Mini 12 volt Battery)
11