Advertisement
LABEL REWINDER ONLY INSTALLATION
If you do not have the printer plate (JPL-6000P), place and align the rewinder behind the
printer and than follow the instructions from STEP 3.
ATTENTION.
The unit is equipped with an
extension plate as default, for this
configuration it is not required to be
used.
STEP 1
Place carefully the printer into the lock guides.
STEP 2
On the back side, place and screw the
rewinder to the printer plate.
Do not tighten the knobs until the rewinder will
be properly aligned to the printer.
STEP 3
Remove the additional support and the outer
disk.
Load the empty cardboard core onto the core
holder.
Slide in the outer disk onto the core holder and
keep it close to the media edge.
Advertisement
