Advertisement
STEP 8
Pull the printed media underneath both printer
and label unwinder.
STEP 9
Remove the additional support and the outer
disk. Load the empty cardboard core onto the
core holder.
Slide in the outer disk onto the core holder and
keep it close to the media edge. Tighten the
knob.
STEP 10
Keeping the printed media underneath the
tension arm, stick the end on the cardboard
core.
Install the additional support.
STEP 11
Once the media is loaded on the rewinder,
slide left and right the rewinder to find the
correct alignment between the two units and
tighten the knobs.
Advertisement
