Kohler C3-420 Installation Instructions Manual page 6

2. Install the Remote Dock
Position the remote dock at the desired mounting location.
Confirm that the remote dock is level.
Using a pencil, mark the two mounting-hole locations. Set the remote dock aside.
For installation into a stud or other wood surface: Drill a 1/16" hole at each of the
marked locations.
For installation using wall anchors: Drill a 1/4" hole at each of the marked
locations. Install the provided wall anchors into the holes.
Position the remote dock over the anchors or marks. Secure the remote dock with
the provided screws.
Open the battery compartment on the remote control.
Install the four provided AA batteries in the orientation shown.
Place the remote control on the remote dock.
1354689-2-D
Remote Dock
1/16" or 1/4"
Holes
6 Kohler Co.