Toshiba SD-38VEKE Owner's Manual page 11

How to install the batteries
Use micro batteries type R03 (AAA/UM-4 Size).
These batteries are offered as carbon / zinc-type or as alkaline-type. You may use both, but do not mix types. The
alkaline type lasts longer compared to the carbon / zinc type but is more expensive.
Note: Flat, weak batteries will leak. Corrosive electrolyte will damage the remote control.
Leak proof batteries will not leak immediately when they are flat. As long as the remote control is still working,
there is no danger of leakage. To prevent damage, remove the batteries if you do not use the remote control
for a long period of time.
Damage because of leakage is not covered by the guarantee.
1
Open the battery compart-
ment cover in the direction of
the arrow.
Distance of Remote
Control Operation
The remote control will not work properly in the following cases:
If bright sunlight
directly beams
onto the unit
front.
If the batteries have not
been installed according to
their polarities.
2K20301A [EN] P08-13
2
Install two "R03/AAA" batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
approx.
7m
11
3
Effective angle:
approx. 60°
Point the remote
control directly at the
remote sensor.
If an obstacle is
placed between the
unit and the remote
control.
If the batteries are
weak.
2/3/07, 2:21 PM
Remote control
Replace the compartment
cover.
11