Set Up The Remote Control - Epson PowerLite S4 Quick Setup Manual

2
Connect your video source
Connect the projector to a computer or video source using any of the available
connections shown below.
•
Check the connectors on your video equipment. If more than one
connection is available, choose the one that provides the best quality.
(The projector connectors from highest to lowest quality are
Computer/Component Video, S-Video, and Video.)
•
A computer cable is included. You can purchase optional video cables
through Epson or at local electronics stores. See the next page for
accessory information.
•
You can connect up to 3 video devices and use the remote control to
switch between them.
Computer
cable
(included)
NOTE To play back audio through the projector, you can connect an audio
cable from your video device to the audio ports on the projector.
See the User's Guide on your CD-ROM for instructions.
3

Set up the remote control

1
Remove the battery cover.
2
Insert the batteries.
3
Replace the battery cover.
The remote control is ready for use.
Component
video to
S-Video
VGA cable cable
RCA video cable
(composite
video)
Audio ports