Test Setup; Figure 2-1. Tlc6A598Evm Test Bench Setup; Table 2-1. Tlc6A598Evm Connectors And Test Points - Texas Instruments TLC6A598 User Manual

Test Setup

2 Test Setup
This section describes the test setup for the evaluation of the TLC6A598EVM board.
connectors and test points.
Reference Designator
J1
J2
J3
J4
J5
J6
J7
TP1
TP2
TP3, TP4, TP5
The following equipment are required for the test setup:
• A power supply 1 capable of supplying 5 V @ 0.3 A is required to supply V
• A power supply 2 capable of supplying 24 V @ 1 A is required to supply V
To evaluate the TLC6A598EVM board, the USB2ANY interface adapter provided by TI is recommended here.
Please download and install the
Figure 2-1 shows the test bench setup for the evaluation of the TLC6A598EVM board.
PC
USB Cable
Set the input voltage power supply 1 to 5 V and the current limit to 0.3 A. Turn off the power supply 1. Connect
the power supply 1 to the J1 and J2 connectors with the positive terminal of the supply connected to V
and the negative terminal of the supply connected to GND (J2). Set the input voltage power supply 2 to 24 V and
the current limit to 1 A. Turn off the power supply 2. Connect the power supply 2 to the J3 and J4 connectors,
with the positive terminal of the supply connected to V
to GND (J4).
4 TLC6A598 Power Logic 8-Bit Shift Register Evaluation Module

Table 2-1. TLC6A598EVM Connectors and Test Points

Function
V
CC
GND for V
CC
V
DD
GND for V
DD
USB2ANY Connector
Outputs connector for TLC6A598
Outputs connector for Relays
Test point for V
CC
Test Point for V
DD
GND Test Point
USB2ANY Explorer Software

Figure 2-1. TLC6A598EVM Test Bench Setup

Copyright © 2021 Texas Instruments Incorporated
CC
.
DD
on the computer.
+5V DC
Edge cable
(J3) and the negative terminal of the supply connected
DD
www.ti.com
Table 2-1 shows the EVM
.
+24V DC
+ +
(J1)
CC
SLIU023 – JUNE 2021
Submit Document Feedback