Cd Player Operation - Jensen JBS-210 User Manual

Bluetooth cd music system with digital am/fm stereo receiver and remote control

Hide thumbs

Table Of Contents

Table of Contents

For best FM reception, the FM lead wire antenna located on the back of the

FM -

unit should be fully unwrapped and extended.

NOTE: Automatic tuning depends on the signal strength of the broadcasting station, so weak

stations may be skipped. You can manually tune to find the weak stations if a station gets

skipped. With strong signals, the tuner may stop before it reaches the actual broadcast

frequency, so you may need to manually tune for the best reception.

PRESET RADIO STATIONS

Press the

Button on main unit or remote control to turn on the unit.

Tap the MODE Button on main unit or remote control to select AM or FM radio mode.

Press and hold the PLAY/PAUSE

readout on the display begins to scan and then release the button for auto search and program

preset channels. "PROG" appears in display and flashing. Auto searching and program will

stop at P01 after scan finished, "PROG" shows in display steadily.

Note: If the channels stored during the auto search & programmed preset are not ones you

want saved, use the method below for the manually saving radio presets.

Tune to the desired radio station either by "manually" or "automatically" tuning method.

Tap the MEMORY Button on main unit or MEM. Button on remote control, the next available

preset memory number and a flashing "MEM" icon will show in the LCD display. (Note:"P01"

will show in the display if you are programming preset for first time)

Tap the PRESET+/- Button on main unit or remote control to select the preset number you

want to assign the station to.

Tap the MEM. Button to confirm the setting.

Repeat above steps 4 - 7 to preset up to 30 FM and 20 AM stations.

RECALLING PRESET MEMORY CHANNELS

In radio mode, recall the pre-set channels by pressing the PRESET+/- Button on main unit or

remote control repeatedly.

Note: This CD player will not only play commercial CDs, but also self-compiled CD-R/RW discs.

Do not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.

PLEASE READ THIS IMPORTANT INFORMATION:

CD mechanisms used in devices like this are designed to read all commercial CDs. It will also read

self-compiled CD-R/CD-RW discs, but it may take up to 10 seconds for the actual playback to begin.

If playback does not start, it is likely due to the quality of the CD-R/RW disc and/or the compatibility

of the CD compilation software. The manufacturer is not responsible for the playback quality of CD-

R/RW discs.

Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.

PLAYING A CD

Press the POWER/STANDBY

Tap the MODE Button on remote control or main unit to select CD mode and then press the

Open/Close

Place an audio CD inside the tray with its printed side facing up.

Press the

button to close the CD tray. Unit starts to read the disc, "- -" shows in display and

flashing. After few seconds, the total number of tracks show one second and then total time of

the CD will be shown on the LCD DISPLAY.