Table of Contents
Advertisement
Install the server on sliding rail assemblies
Figure 12 Installing sliding rail assemblies
This procedures describes installation of the server on the sliding rail assemblies.
CAUTION
The server is heavy and should be installed in a cabinet by two people. To avoid
personal injury and/or damage to the equipment, do not attempt to install the
server in a cabinet without a mechanical lift and/or help from another person.
Procedure
1. Pull the inner slide rails out of the cabinet until they lock into place (1).
2. With the help of second person, position the server above the extended rails.
3. Locate the rear rail standoff on each side of the server and lower them into the
rear J-slots on the slide assemblies (2).
4. Rotate the server downward until all the rail standoffs are seated in the J-slots
(3).
5. Push the server inward until the lock levers click into place.
6. Press the slide-release lock buttons on both rails (4).
1U1N Configuration Equipment Installation
Install the server on sliding rail assemblies
35
Advertisement
Table of Contents
