Gigabyte S452-Z30 User Manual page 94

Parameter
USB Configuration Options
SD Dump Options
AC Power Loss Options
I2C Configuration Options
Uart Configuration Options
ESPI Configuration Options
BIOS Setup
Description
Press [Enter] for more options.
XHCI Controller0 Enable
Š
– Enable or disable USB3 controller.
– Options available: Enabled/Disabled/Auto. Default setting is Auto.
XHCI Controller1 Enable
Š
– Enable or disable USB3 controller.
– Options available: Enabled/Disabled/Auto. Default setting is Auto.
USB ecc SMI Enable
Š
– Options available: Enabled/Off/Auto. Default setting is Auto.
MCM USB enable
Š
– Press [Enter] for advanced configurations.
Press [Enter] for more options.
SD Configuration Mode
Š
– Select SD Mode.
– Options available: SD Dump disabled/SD Dump Enabled. Default
setting is SD Dump disabled.
Press [Enter] for more options.
AC Loss Control
Š
– Select AC Loss Control Method.
– Options available: Power Off/Power On/Last State. Default setting
is Last State.
Press [Enter] for more options.
I2C 0/1/2/3/4/5 Enable
Š
– Enable or disable I2C 0/1/2/3/4/5.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
Uart 0 Enable
Š
– Uart 0 has no HW FC if Uart 2 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 1 Enable
Š
– Uart 1 has no HW FC if Uart 3 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 2 Enable (no HW FC)
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart 3 Enable (no HW FC)
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Press [Enter] for more options.
ESPI Enable
Š
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
- 94 -