Temperature Probe Installation (708-Ds); Figure 8 Bath Temp Connector; Figure 9 Positioning The Temperature Probe - Agilent Technologies 709-DS Operator's Manual

Temperature Probe Installation (708-DS)

708-DS / 709-DS Operator's Manual
1 Insert the water bath temperature probe into the BATH TEMP jack
on the rear of the dissolution apparatus drive unit.
Figure 8 BATH TEMP Connector
2 Place the other end of the temperature probe through the hole in the
center of the vessel plate in the water bath.
Figure 9 Positioning the Temperature Probe
Setting Up the 708-DS / 709-DS 3
29