Philips 231T1SB/00 Service Manual page 87

7.14 Base Tilt / Swivel Range
Tilt
Swivel range
Base detach
Tip over
7.15 Movement of Unit with Base
Base must have non-marring, non-staining feet.
Unit must tilt up and down with no "Stick / Slip".
Base must provide sufficient friction to hold unit in desired position after adjusting tilt.
7.16 Kensington Lock
Must meet Kensington_slot spec "TYE-M0004"
MMD request metal plate in Kinsignton hole.
7.17 Wall Mount Method
VESA standard 100mm x 100mm
7.18 Label
Regulatory label / Carton label should follow Philips requirement.
China RoHS label.
Detail document refer to Philips Engineering Reference Book.
7.19 Product Dimension / Weight
Refer to final approved SHT191 / SHT560
Unit dimension (with stand) -
Packed unit dimension (carton) -
Net weight -
Gross weight -
7.20 Transportation
Transportation standards refer to UAN-D 1534 / 00 / 01 / 02.
7.20.1 Transportation packages
Packaging and wrapping shall be sufficient to protect the product against damage or loss during shipment from
the supplier to the destination specified in the purchase order. All packaging materials are subject to test and
evaluation per UAN-D 1534/00/01, UAN-D636 and UN-D 1400.
General pallet requirement refer to wood packaging reqs SBMT-ISBM15-16-03-06.pdf.
The cushion material shall be constructed using EPS material.
The doggy hole is requested.
7.20.2 Transportation test
The overall testes refer to UAN-D 1534/00/01/02.
Vibration, drop test should be performed at ambient temperature (20°C to 23°C) and relative humidity (40% to
65%).
-5 ° +2/-0 ° (forward)
Nil
Should be directly disaasembled from main body, so as for easy install the set to
wall mount.
10° minimum in worst case, base dimension designed so that ID and tip over
requirements can be met
+20 ° +0°/-2°(backward)
Meridian 1 87