Summit SP7D2 Owner's Manual page 13

Major Adjustment:
Note: The slides have extra mounting holes that may be used.
1. Remove one slide's mounting screws.
2. Reposition the slide so it is the same distance from the bottom of the liner as the other slide. Measure
to confirm.
3. Mark new drilling holes using different sets of mounting holes on the slide.
Note: Front location holes are shown. Corresponding rear holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
RE-INSTALLAT ION OF DRAWER
Caution:
Use care when handling the drawer. Drawer edges, drawer rail and the unit's slide may
be sharp.
1. Set the drawer's rails onto the slides.
2. Re-install the rails' mounting screws.
3. Plug in the drawer's connection wiring
12