Summit SP7D2 Owner's Manual page 11

1. Remove the slide's mounting screws.
2. Reposition the slide so it is the same distance from the front of the liner as the other slide. Measure to
confirm.
3. Mark new drilling holes using different sets of mounting holes on the slide.
Note: Front location holes are shown. Corresponding rear holes will also need to be marked.
4. Drill all the new holes with a #30 drill bit.
5. Remount the slide.
FRONT-TO-BACK ADJUSTMENT
The drawer will need a Front to-Back Adjustment if, when viewed from the side, the drawer front is cocked
forward or back. This is caused by the front slide mountings not being level with the rear slide mountings.
Minor Adjustment:
Note: The mounting holes on the slide are slightly larger than the screws' diameter.
1. Loosen one slide's mounting screws.
2. Level the slide.
3. Retighten the screws.
4. Repeat procedure for the other slide.
10