Summit SP7D2 Owner's Manual page 12

Major Adjustment:
Note: The slides have extra mounting holes that may be used.
1. Loosen one slide's rear mounting screws.
2. Remove the slide's front mounting screws.
3. Reposition the slide so it is level.
4. Mark new front drilling holes using a different set of mounting holes on the slide.
5. Drill the new holes with a #30 drill bit.
6. Remount the slide.
7. Repeat procedure for the other slide.
TOP-TO-BOTTOM (AND LEFT-TO-RIGHT) ADJUSTMENT
The drawer will need a Top-to-Bottom Adjustment if, when viewed from the front, the drawer is not level
horizontally. Viewed from the top, one side will protrude. This is caused by one of the slides being
mounted higher than the other slide on the unit's liner.
Minor Adjustment:
Note: The mounting holes on the slide are slightly larger than the screws' diameter.
1. Loosen one slide's mounting screws.
2. Push the slide upward or downward to match the position of the other slide.
3. Retighten the screws.
4. Repeat the procedure with the other slide if necessary.
11