Stihl MS 201 C-M Instruction Manual page 16

English
► Rotate the captive nut (1) counterclockwise
until it hangs loosely in the sprocket cover.
► Remove the sprocket cover (2) with captive
nut.
6.3 Mounting the Guide Bar
► Turn the screw (1) counterclockwise until the
tensioner slide (2) butts against the left end of
the housing slot.
4
► Fit the guide bar over the stud (3) and engage
the peg of the tensioner slide in the hole (4).
6.4 Fitting the Chain
WARNING
Wear work gloves to protect your hands from the
sharp cutters.
1
► Fit chain around the sprocket (1) and over the
guide bar – the cutting edges on top of the bar
must point to the bar nose.
16
1
2
3
6 Mounting the Bar and Chain
2
► Turn the screw (2) clockwise until there is very
little chain sag on the underside of the bar –
and the drive link tangs are engaged in the bar
groove.
► Refit the chain sprocket cover –
the pivot pin on the hand guard must engage
the sleeve – and then screw the nut onto the
stud finger-tight.
► Go to chapter on "Tensioning the Saw Chain"
0458-598-0121-C