Solving Problems
74
Solving Problems With the Image
or Sound
No image appears on the screen.
Check that the Ppower light is green (not flashing) and that the
■
slide is open. Also press the
A/V Mute
remote control to make sure the picture has not been turned off
temporarily.
The projector may be in standby or sleep mode. If the Ppower
■
light is orange, press the Ppower button to turn the projector on.
If the power was switched off and then on again, the projector
■
may be cooling down. Wait until the Ppower light stops flashing
and remains orange; then press the Ppower button again.
The attached computer may be in sleep mode or displaying a
■
black screen saver. Try pressing a key on the computer.
If you are projecting from a DVD player or other video source,
■
make sure you turn it on and press its
If you are projecting from a composite or S-Video video source,
■
make sure the Video Signal setting is correct (see page 49).
You can also try resetting all of the menu settings (see page 47).
■
You've connected a computer and see a blue screen with the
message
displayed.
No Signal
■
Make sure the cables are connected correctly, as described
beginning on page 27.
■
If you've connected a computer and one or more video sources,
you may need to press the
correct source. Allow a few seconds for the projector to sync up
after pressing the button.
■
Make sure the power for your connected equipment is turned on.
A/V Mute
button.
Play
button to select the
Source Search
button on the