TRENDnet EasyMesh TEW-832MDR User Manual page 11

TRENDnet User's Guide
5. When reaching the final step, if setting up one router only, tap Done at the bottom of
the screen. Connect to the router's wireless network and click Login to connect to the
router with the new settings.
6. To add an additional node, Login, to your mesh network and click the + button
towards the bottom of the home screen. Click on Start Pairing to initiate the pairing
process.
Note: The additional unit may take up to one minute to boot up. When the unit LED
changes from white to orange, this indicates that the unit is ready for setup. Please
make sure that the location of the additional unit is within at least 3m (9.84 ft.) range
of the master router for initial setup.
7. Push and hold the WPS/RESET button for 3 seconds on the new unit. Once initiated,
the WPS/RESET LED will begin blinking green while pairing to the Mesh network.
Note: Holding the button longer than 5 seconds will reset the unit back to factory
defaults
© Copyright 2021 TRENDnet. All Rights Reserved.
8. The Pair LED light will turn solid green when your new Remote node is connected
with a solid connection.
Note: If the Pair LED light is still blinking, please move the Remote unit closer to the
other Mesh nodes.
9. Your WiFi mesh network setup is complete.
TEW-832MDR / TEW-832MDR2K
10