Replacing An Ink Cartridge; Testing The Printer - Epson Stylus Photo R320 Product Information

Epson Stylus Photo R320
7. If you like, you can make further changes before printing.
8. Press the button. Your print job begins printing.
Print
Note: To cancel a print job while printing, press the
Keep your pictures and unused paper away from high
temperatures and humidity and out of direct sunlight.
Additional Stand-alone Features
See Printer Basics for information on other features that are
available when printing without a computer:
cropping, adjusting, and enhancing photos
using a CD-R drive or Zip drive to back up photos from a
memory card
Printing from a Bluetooth-enabled device with the optional
Bluetooth adapter.

Testing the Printer

You can run a printer check to determine whether a problem
comes from the printer itself or some other source.
1. Make sure both the printer and computer are turned off.
Then disconnect the USB cable from the printer.
2. Make sure letter-size or larger paper is loaded in the printer.
3. Turn on the printer.
4. Press the (
Maintenance
5. Press the button to highlight
.
OK
6. Use the or button to highlight
then press .
OK
7. Press to print the nozzle check.
OK
8. The printer prints a page showing a nozzle check pattern. (If
the pattern has gaps, you need to clean the print head; see
page 10.)
If the check page printed, the problem probably lies in
your memory card, software settings, interface cable, or
computer, or your software may not be installed
correctly.
8 Epson Stylus Photo R320
-
Stop button.
button.
, then press
More Options
Nozzle Check
If the check page did not print, you may have a problem
with your printer. Try the suggestions in Printer Basics.
9. After examining the check page, remember to turn off the
printer and reconnect its cable to your computer.

Replacing an Ink Cartridge

You can check the status of the ink cartridges by looking at the
icons on the control panel. Press the
to
More Options
Ink cartridge levels
The level of ink shown on the icons indicates the approximate
amount of ink remaining. If an ink cartridge is low, the red b
error light flashes. This is a good time to make sure you have a
new cartridge. If an ink cartridge is empty, the red b error
light remains on and you see a message on the display telling
you that the cartridge needs to be replaced.
Caution: You cannot print if any ink cartridge is empty. Leave the
empty cartridge installed in the printer until you have obtained a
replacement, otherwise the ink remaining in the print head nozzles
may dry out. To ensure good results, use genuine Epson ink
cartridges and do not refill them. Other products may cause damage
to your printer not covered by Epson's warranty.
When an installed cartridge is more than six months old, you
may need to replace it if printouts don't look their best. If the
quality doesn't improve after cleaning and aligning the print
head, you can replace the cartridge even if the b error light is
off.
Use these Epson ink cartridges within six months of installing
them and before the expiration date on the package:
,
When you need new ink cartridges, contact your dealer or
call the Epson Store at (800) 873-7766 or visit
www.epsonstore.com (U.S. sales only). In Canada, please call
(800) 463-7766 for dealer referral.
7/04
button to scroll down
.
Cartridge Part Number
Black T048120
Magenta T048320
Cyan T048220
Yellow T048420
Light Magenta T048620
Light Cyan T048520