Install Software - Epson Stylus Photo R2400 Start Here Manual

5
5

Install Software

Install Software
Windows
®
The software works with Windows 2000 and XP. Make sure
your printer is NOT connected to your computer, then follow
the steps below.
1
Turn on your computer. Wait for the system to start up,
then insert the Epson
NOTE: If you see a screen like this, click Cancel
and disconnect the printer from your computer.
Then follow the steps below.
2
Read the license agreement that appears and click
AGREE.
3
You see a message like this.
Click OK to begin installing your printer driver.
4
When you see this screen, follow the steps below to
connect EITHER a USB cable or a FireWire
USB
Connect the square end of your USB cable to the
back of your printer and the flat end of the USB
cable to your computer. (You can connect to any
open port.)
NOTE: For Windows XP, if you don't have USB 2.0, you see a message. Click the
Close button to close the message.
FireWire
Connect one end of the FireWire cable to the back of your printer and the other end to
your computer.
NOTE: If your computer uses i.Link or another 4-pin FireWire connection, you will
need to connect a 6-pin to 4-pin FireWire (IEEE 1394) cable.
5
When you see this screen, click Next.
® CD-ROM in your drive.
® cable.