Table of Contents
Advertisement
■ Indicators and buttons
F
SD ON/OFF button
G
AF button
H
TELE button
I
WIDE button
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
A
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an
external power supply, disconnect the power cord plug (accessory) from the power supply
terminal (12 V DC).
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
When the camera is initialized, the settings including the network settings will be initial-
ized. Before initializing the settings, it is recommended to write down the settings in
advance.
D
o not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor ⇔
PAL monitor.
B
LINK indicator
When the camera is able to communicate with
the connected device
C
ACT indicator
When data is being sent via the network camera
INITIAL SET button (Initializing / NTSC ⇔ PAL switch button)
A
LINK indicator
B
C
ACT indicator
20
E
SD ERROR/AF indicator
D
SD MOUNT indicator
SD slot
Lights orange
Blinks green (accessing)
Advertisement
Table of Contents
