Table of Contents
Advertisement
When connecting to a network using a PoE hub
Before starting the installation, check the entire system configuration. The following illustration gives
a wiring example of how to connect the camera to the network via a PoE device (hub).
Powered speaker
Microphone
(Plug-in power type)
Powered speaker
Microphone
(Plug-in power type)
IMPORTANT:
Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX.
If a PoE hub is not used, each network camera must be connected to a 12 V DC power
supply.
When using 12 V DC, power supply from a PoE hub or router is not required.
Adjustment monitor
WV-S2250L
Ethernet cable
(category 5e or
better, straight)
WV-S2250L
Adjustment monitor
19
PoE device (hub)
Ethernet cable
(category 5e or better,
straight)
Ethernet cable
(category 5e or better,
straight)
Use an Ethernet cable (category
5e or better, cross) when directly
connecting the camera to a PC.
PC
Advertisement
Table of Contents
